iZETTLE - TSP650ii Ethernet/Bluetooth Set Up and Install

Installation Checklist

 

TSP650 Ethernet

  • Connect Ethernet cable into 100/10BASE port
  • Connect Cash Drawer into DK port
  • Connect the power cable and switch the printer on
  • Insert Paper using the guide on the next page
  • Perform a Self Test to make sure IP address provided
  • Open Pro and configure the printer within the App

TSP650 Bluetooth

  • Connect Cash Drawer into DK port
  • Connect the power cable and switch the printer on
  • Insert Paper using the guide on the next page
  • Pair the printer via Bluetooth using the steps provided in the next few pages
  • Open Bluetooth Settings on iPad and pair the Star printer
  • Open Pro and configure the printer within the App

Performing a Self Test

  • Switch the Printer off
  • Press and hold the Feed button
  • Switch the printer back on whilst still holding down the feed button, and release after 3 seconds the Printer off
  • Wait for the second test receipt to print
  • We should now see an IP address on the bottom of the second receipt (see picture below)
 

Inserting the receipt paper

Insert the roll with the outer shiny side of the paper facing downwards, and the inside of the roll facing you

Once you have done this, pull out a little bit of receipt paper, so that when you have closed the latch the automatic feed and cut takes place, preventing blockages. 


On the TSP650 Bluetooth, the LED at the back will be solid green, indicating no activity. Press and hold the PAIR button for 5 seconds and when you let go the green LED should blink. 

If you go into Settings on the iPad, then tap on Bluetooth, you should see Star Micronics appear in Other Devices. Tap on this to start pairing. 

Once fully paired the LED at the back of the printer should now turn to solid blue, indicating it has been connected with the iPad and ready to be used. 


When in the sales screen tap on the small cog at the top left

Select Printers - You should now see an unnamed printer appear. If you tap on this you can now go ahead to set it up. The TSP650 Bluetooth will show as above with a Bluetooth icon after you have paired it in the Bluetooth settings. 

Switch on Standard Receipts and also Cash Drawer. If the customer would like to set the printer up to also print "station" receipts you can do this here. You can also rename the printer, which is recommended especially if the customer has more than 1 printer.